Dynamic Positioning (DP) – Technical 3 days
Dynamic Positioning (DP) – Technical 3 days
Purpose
The purpose of this course is to provide Dynamic Positioning Technical training to a standard adequate to fulfil the requirements of the industry and of the various legal bodies and institutions involved.
Content
The training will follow the programme as outlined by the manufacturer of the DP system, which follows the recommendations contained in The International Marine Contractors Association (IMCA) guidelines.- Outlining the national and international rules and regulations valid for Dynamic Positioning operations
- Technical knowledge of the computers in the DP system
- Preventive and corrective maintenance of the DP system
- System documentation
Objectives
Learn to identify faulty units and exchange these with spares from stock on board and bring the DP system back into operation.
Receive introduction to system documentation in order to perform periodic maintenance, and to communicate with service personnel when assistance is needed
Receive introduction to system documentation in order to perform periodic maintenance, and to communicate with service personnel when assistance is needed
Admission Requirements
Participated in DP introduction or DP Basic course
Target Personnel
Electrical/electronic engineers and maintenance personnel who are responsible for the daily maintenance of the DP system.Duration
Three days
Participants
Maximum six participants
Language
Course material is in English. Course can be conducted in English or Danish.
Venue
Maersk Training Svendborg
Next Course
07.03.2012
08.30 h - 17.00 h
08.30 h - 17.00 h
0 seats
available
available
